Cissell cissiman38 User Manual

The “Tower of Power” is at your fingertips for all of the finishing combinations you will
ever need.  All three timers (steaming, conditioning, drying) are adjustable from 0 to 30
seconds.  The cycle switch provides (presteam only, steaming-conditioning-drying,
steam & air-conditioning-drying) which ever is required.  The white switch allows you
to have air only for sizing and provides a cancel position to terminate the cycle at any
time.  The automatic push-to-start switch is available on the tower or by the foot
switch.  The lights will glow whenever you are in any of the timer periods.  Damper
control lever is on top of tower.
Where possible, perform all touch-up of sleeves, collars, trim, etc., prior to finishing on
the Genie.  In this way, differences in sheen will be eliminated from the garment.

When finishing knits or soft unlined woolens, place net overbag on form before posi-
tioning garment.  After garment is positioned on form, repeat Step #2 in Operating
Instructions.  Push damper knob all the way to obtain full air pressure and repeat step
6 to start cycle.

To finish coats and other open front garments, use front paddle clamp to hold front of
garment in place.  Use the hand vent clamps to hold rear vent or pleat.

When additional moisture is needed for hard set wrinkles, use the water spray gun,
spraying into the steam from a distance of approximately 15”.  Rotate the garment to
the spray gun, using the turning knob on the revolving assembly.

Keep the nylon bag clean and in good repair.  A vacuum cleanable air filter is provided
to help keep the bag clean.  Vacuum clean the filter weekly.  Remove nylon bag (see
detailed instructions) and wet clean as required.  Repair holes or worn spots.  To obtain
proper characteristics of cloth porosity, bag size, and control strings, use only genuine
Cissell replacement bags.