Directed Video HVM500 User Manual

© 2001 Directed Electronics, Inc.  

Screen size

5"

Resolution

74,880 pixels 

View angle

Top 30 degrees 
Bottom 10 degrees
Left 45 degrees
Right 45 degrees

Video system

ntsc/pal

Osd language

English

Power requirements

10 - 15 vdc

Operating temp.

35 - 115 degrees 
fahrenheit

The Directed HVM 500 5" monitor comes with a

mounting bezel designed for headrest installations.

1.

Remove the headrest cover to determine if
it has room in it for the monitor without
structurally weakening it. 

2.

With the cover still removed, position the
cutout template against the rear of the
headrest and mark the area to be cut out. 

3.

Remove the material to a depth sufficient
for the lip of the mounting bezel to fit
flush against the rear of the headrest once
installed.

4.

Cut an access hole for the cable to exit
next to the headrest adjustment bar.

5.

Reinstall the headrest cover. Trim it to the
size of the mounting bezel hole. When
trimming, it is best to leave extra materi-
al that can be glued into the hole before
installing the mounting bezel.

6.

Route the cable through the headrest
access hole and the rear opening of the
mounting bezel. Leave enough slack in the
cable for monitor installation.

7.

Install the bezel. Some headrests have
material that is strong enough to screw
the bezel into. Others will require quality
adhesive for mounting. 

8.

Route the cable through the seat cover
and reinstall the headrest. Leave enough
slack in the cable so the headrest still has
full movement during adjustment.

9.

Install the monitor into the mounting
bezel and adjust to the proper angle.  

10.

Complete the cable routing to the video
source.