Manualsbrain.com
  1. Manuals
  2. Brands
  3. Dacor
  4. DYF48BNDI
  5. User Manual

Dacor DYF48BNDI User Manual

Download
Page of 22
10
Handles
•  Before installing a custom panel assembly, you must install the 
custom handle hardware. The handle and handle mounting 
hardware are not provided with the refrigerator.
•  Dacor recommends handles with larger D-style pulls. Any 
handle designed for use with an appliance should produce 
satisfactory results. Handle kits are available through your 
Dacor dealer.
•  Handle kits do not include the necessary mounting screws 
since screw length required varies with the total thickness of 
the panels. The panel craftsman must determine and obtain the 
proper fasteners for the application. If using screws with thick 
heads, they must be countersunk into the panel before installing 
the handles.
IMPORTANT: Dacor does not advise the use of single pull knobs.
Custom Side Panels
Custom side panels may be needed when not enough space is 
available to have cabinets on both sides of the refrigerator or 
when the refrigerator is placed at the end of a cabinet run. You 
may choose an inset, flush or recessed inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type 
of installation you are planning.
NOTES:
 
ƒ
The dimensions shown are actual product dimensions and 
may not reflect the needed installation dimensions.
 
ƒ
The side panel should be a minimum of ½” (1.3 cm) thick to 
avoid warping.
 
ƒ
If the opening depth is 25” (63.5 cm) or more, you may want to 
install a support board on the rear wall.
Inset Installation Dimensions
1.  Measure the distance from point A (as shown) to the back 
wall. Add 
1
⁄
32
” (0.8 mm) to this measurement to allow the side 
panel to fit into the trim.
2.  If the panel is more than 
3
/
8
” (9.5 mm) thick, route the front 
edge to allow the side panel to fit into the trim.
Recessed Inset Installation Dimensions
1.  Measure the distance from point B (as shown) to the back 
wall.
2.  Rout the front edge of the support board or attach a  
3
/
8
” (9.5 mm) board to hold the panel in the cabinet side trim.
Installation Requirements
Back wall
A
Back wall
B
1
⁄
16
” (1.5 mm)
3
⁄
32
” (2.4 cm)
Side Trim
3
⁄
8
” (9.7 mm)
3
⁄
16
” (4.8 mm)
20” typ. 
(50.8 cm)
36” max.
(91.4 cm)
A.  Countersunk screw
B. Handle
C.  Door panel assembly
Trim frame
A
B
Door
Handle Detail
C
23
11
⁄
16
” 
(60.2 cm)
Overlay
Refrigerator