Behringer Europower PMP4000 User Manual

EUROPOWER PMP1000/PMP4000/PMP6000 User Manual

For stereo operation the POWER AMP switch  

(27)

  must be set to its upper position 

(MAIN or MAIN L/MAIN R). Outputs A and B provide the stereo main signal for 
passive speakers. The preamp monitor output is connected to two parallel active 
speakers, which are used as on-stage monitors. Use the footswitch to enable/
disable the effects processor.

This illustration shows the power mixer with a sub-woofer connected to 
OUTPUT B. For a bridged mono operation to OUTPUT B, the AMP MODE selector 
switch  

(27)

  must be set to its lower position “BRIDGE”. A separate stereo power 

amp (BEHRINGER EUROPOWER EP2000) connected to the preamp main outputs 
delivers the stereo main signal. Two active monitor speakers for on-stage 
operation are connected to the preamp monitor output.

PMP1000

PMP4000

PMP6000 

(part view)

2 x BEHRINGER EUROLIVE Stack 

(B1800X & B1220, both passive)

2 x BEHRINGER F1220D 

(active)

front panel (part view)

Footswitch

Link Output

Fig. 5.1: Stereo operation

PMP1000

PMP4000

PMP6000 

Rear panel

EUROPOWER EP2000

EUROLIVE 

VP1520

EUROLIVE B1800X 

Subwoofer

2 x BEHRINGER F1220D 

(active)

Fig. 5.2: Bridged mono operation