Cadillac seville 2002 User Manual

This feature will allow the individual tire pressure
readings to be displayed when using the INFO button to
scroll through the DIC displays. Even with this feature
programmed to be turned off, a low or high tire pressure
condition will still cause the CHECK TIRE PRESSURE
message to be displayed on the DIC. See “Driver
Information Center (DIC) Messages” in the Index 
for more information.

Mode 1: ON

Mode 2: OFF

Before your vehicle was shipped from the factory, it was
programmed to Mode 1. The mode to which the vehicle
was programmed may have been changed since it left
the factory. To determine the mode to which the vehicle
is programmed or to program the vehicle to a different
mode, do the following:

1. Enter FEATURE PROGRAMMING following the

instructions listed previously.

2. Press the down arrow on the INFO button until TIRE

PRESSURE DISPLAY appears on the DIC display.

3. To turn on the feature, press the ON/OFF button

until ON appears on the DIC display. To turn it off,
press the ON/OFF button until OFF appears on 
the display.

The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.

This feature allows individual driver’s names to be
displayed in the DIC when the ignition is turned to ON.
This feature only works when the remote keyless entry
transmitter is used to unlock the vehicle or when buttons
1 or 2 on the driver’s door are pressed. See your dealer
for assistance in programming this feature.

To exit FEATURE PROGRAMMING, press the 
INFO RESET or INFO button.