Fujitsu deskpower 6000 User Manual

39

– Serial Port 2

This item sets the I/O port address and interrupt number of serial port 2.

-

Disabled
Serial port 2 is disabled and resources are freed.

-

Enabled (Initial value)
Set the I/O port address and interrupt number of serial port 2.

-

Auto
The personal computer automatically assigns an I/O port address and an interrupt
number.

- When ‘Serial Port 1’ is [Disabled], the port is not transparent to devices controlled by the

Windows 95/98 APM device manager.

- To disable the serial port on Windows 98 ACPI, use the Windows 98ACPI device

manager.

Mode

This item appears when ‘Serial Port 2’ is [Enabled]. Set the operating mode of serial port 2.

-

Serial connector (Initial value)
Serial port 2 is used as serial connector 2.

-

IrDA
Serial port 2 is used as an infrared ray port.

I/O Address

This item appears when ‘Serial Port 2’ is [Enabled]. Set the I/O address of serial
port 1.

-

3F8 to 3FF, 2F8 to 2FF, 3E8 to 3EF, and 2E8 to 2EF (Initial value: 3F8 to 3FF)

Interrupt

This item appears when ‘Serial Port 2’ is [Enabled]. Set the interrupt number of serial port 1.

-

IRQ3, IRQ4, IRQ10, IRQ11 (Initial value: IRQ3)

– Parallel Port

This item sets the I/O port address and interrupt number of a parallel port.

-

Disabled
The parallel port is disabled and resources are freed.

-

Enabled (Initial value)
Set the I/O port address and interrupt number of the parallel port.

-

Auto
The computer automatically assigns an I/O port address and an interrupt number.

- When ‘Parallel Port’ is [Disabled], the port is not transparent to devices controlled by the

Windows 95/98 device manager.

- When ‘Parallel Port’ is [Auto], connected printers may not operate correctly, in which

case set [Enabled].