Fujitsu deskpower 6000 User Manual
51
4
2
Enter a password not exceeding seven digits.
The password can contain alphanumeric characters.
The entered characters are not displayed and “ ” appears.
The minimum length of user passwords can be set in ‘Set User Password Length.’
3
After entering a password, press the Enter key.
The cursor moves to the “Enter New Password” field and the utility requests that the
password be entered again.
4
Enter the same password as in Step 2 again and press the Enter key.
The Notice window appears.
5
Press the Enter key to complete the password setup.
If the reentered password is incorrect, a Warning! window appears. Press the Enter key to
retry from Step 2.
To cancel password setup, press the Esc key.
- If the user boots a setup with a user password when the supervisor and user passwords
are set, the following items may not appear on the menu:
Set Supervisor Password
Diskette access
Fixed disk boot sector
Set Supervisor Password
Diskette access
Fixed disk boot sector
- If the user enters a wrong password three times, the message “System stopped”
is displayed and the PC does not respond to keyboard entry. In such a case, press the
Power switch for at least four seconds to turn the PC off. After waiting at least ten
seconds, turn the power on again and enter the correct password.
Power switch for at least four seconds to turn the PC off. After waiting at least ten
seconds, turn the power on again and enter the correct password.
6
Exit the BIOS setup utility and turn off the power.
7
Set the jumper switch of the personal computer.
Change jumper switch JP5 from 2-3 to 1-2 on the computer. (For the location of jumper
switch JP5, see the following page.)
Point