Fujitsu fs-1108au-fs1108mu User Manual

 

In addition, when the [ServerSelection] switch on the left side of the front panel, the 
[AutoScan] switch, and the [RESET] switch are pressed at the same time, various 
settings are initialized as shown by the following table. 
 

Server name

 

Initialized

 

AutoScan frequency

 

Initialized 

 

Normal display status

 

Initialized

 

Setting for whether to display when AutoScan is being performed

 

Initialized  
(display is enabled)

 

HOTKEY settings

 

Initialized 

 

Country code setting

 

Settings retained

 

POWER SUPPLY:ALWAYS ON

 

Settings retained

 

EDID

 

Settings retained

 

SELECT-A/B

 

Settings retained

 

 
(5) Ports for server connection 

The ports of a KVM Switch are connected to the keyboard/mouse/monitor connectors by 
using dedicated cables. 

 

(6) Monitor connector 

The monitor connector is used to connect the monitor to a KVM Switch. 

 
(7) Keyboard connector 

The keyboard connector is used to connect the PS/2 keyboard to a KVM Switch. 

 

(8) Mouse connector 

The mouse connector is used to connect the PS/2 mouse to a KVM Switch. 

 

(9) USB keyboard/mouse connector 

The USB keyboard/mouse connector is used to connect a USB keyboard, mouse, or 
hub to a KVM Switch. 
It does not matter which of these is connected for operation. 
Devices other than a USB keyboard, mouse, or hub cannot be connected. 
The maximum number of devices that can be connected is as follows. 

 

4 port type

 

8 port type

 

Keyboards: 2 
Mouse devices: 3 
Hubs: 1

 

16 port type

 

Maximum total number of keyboards and mouse 
devices: 4 
Maximum number of hubs:1 level

 

 

Note that when wireless type devices are connected using a wireless receiver, a signal 
may be output that a mouse or keyboard is connected even though a keyboard or 
mouse is not actually connected.