Fujitsu fs-1108au-fs1108mu User Manual
2 3
11. KVM Switch Operation
Point
Perform the EDID settings first.
When a monitor is connected to a KVM Switch for the first time, the Plug and Play data (EDID
data) must be set. After performing the EDID data settings, the connected monitor can be
used in a suitable environment by restarting the server. In addition, because the set EDID data
is emulated for all of the ports, even if a server is started without any selected ports, the
connected monitor can still be used in a suitable environment.
For details about EDID settings, refer to [11-1-4 Plug and Play Data (EDID Data)
Settings].
data) must be set. After performing the EDID data settings, the connected monitor can be
used in a suitable environment by restarting the server. In addition, because the set EDID data
is emulated for all of the ports, even if a server is started without any selected ports, the
connected monitor can still be used in a suitable environment.
For details about EDID settings, refer to [11-1-4 Plug and Play Data (EDID Data)
Settings].
11-1. Customer Mode Settings
11-1-1. Hotkey Mode Settings
The following two modes are available for the Hotkey mode. The Hotkey mode can also be
turned OFF.
MODE-1: The "SERVER SELECTION" screen or the "CUSTOMER MODE" screen is
displayed
MODE-2: The "Server name" is displayed
The operations listed in the following table change the mode to the Hotkey mode and display
the OSD screen.
Operation
Hotkey mode default value
(1) <Ctrl> + <Alt> + <Shift> are pressed at the
same time
MODE-1
(2) <CTRL> is pressed twice in succession
MODE-2
(3) <ScrollLock> is pressed twice in
succession
MODE-1
(4) The central mouse button is pressed
OFF
If <N> or the right button is pressed in MODE-1 of the Hotkey mode, the mode becomes the
Customer mode. By moving the cursor to the desired mode (MODE-1, MODE-2, OFF) and
pressing <Enter>, the mode can be selected. Use the arrow keys (<↑> and <↓>) to select the
mode. Press <Enter> to set the mode.
The mouse can also be used to set the mode.
Customer mode. By moving the cursor to the desired mode (MODE-1, MODE-2, OFF) and
pressing <Enter>, the mode can be selected. Use the arrow keys (<↑> and <↓>) to select the
mode. Press <Enter> to set the mode.
The mouse can also be used to set the mode.
*Note. Although the mode can be set relatively freely (for example, "MODE-1" can be set for
(1), (2), and (3) in the table above), "MODE-2" cannot be set for (1), (2), and (3) in
the table above. In addition, (1), (2), and (3) cannot all be set to OFF.
the table above. In addition, (1), (2), and (3) cannot all be set to OFF.
*Note. To display the OSD screen, video signal input from at least one connected server is
required. If the video signal cannot be input from a server due to settings such as the