Lumiscope 1143 User Manual

A.  Remove all watches, jewelry, 

etc. prior to attaching the wrist 
monitor. Clothing sleeves 
should be rolled up and 
the cuff should be wrapped 
on bare skin for correct 
measurements.

B.  Apply cuff to left wrist with 

palm facing up as Fig. A.

C.  Make sure the edge of the 

cuff is about 1 cm (1/2 an 
inch) from the palm as Fig. B.

D.  In order to insure accurate 

measurements, fasten 
the velcro strap securely 
around your wrist so there 
is no extra space between 
the cuff and the wrist.

 

Note: If the cuff is not wrapped tight enough, the measurement 

values will be inaccurate.

10

Fig. A

Fig. B

13

Note: In order to get your correct measurement result and, 
to avoid  erroneous measurements, you should be seated 
quietly. Your arm, hand, and fingers should be still during the 
measurement procedure

.

 A.  Press the “START/STOP” button. The display will initially 

show a flashing “0”.

B.  After the “0” stops blinking, the unit will automatically 

inflate to the appropriate inflation level based on the 
user's pulse oscillations. Measurement will then begin. 

Start / Stop