Jacuzzi led series j-230 User Manual

Page of 43
page 15
• 
The heater operates until the water reaches the programmed “set 
 
temperature”, then turns off.  The heater will reactivate after the
 
water cools to approximately 1.5° below the set temperature.
8.  Place Cover On Spa
•   Keeping the insulating cover in place anytime the spa is not  in use 
will reduce the time required for heating, thereby minimizing operat-
ing costs.
•   The time required for initial heat-up will vary depending on the start-
ing water temperature.
DANGER: Risk of injury, always check water temperature carefully 
before entering spa!
Decontamination Procedure (Steps 9-15)
Steps 9-15 pages 15-16 are only required when sanitizer levels are 
unstable after performing steps 1-6 above.  Disregard steps 9-15 below 
if sanitizer levels remain stable at 3 ppm to 5 ppm after performing steps 
1-6.
9.  Add 2.5 ounces of sodium dichlor for every 100 gallons of water. 
Refer to the table below for approximate water fill volume by model. 
 
CAUTION: Never add chlorine tablets (trichlor) to your spa for any rea-
son!  This chemical may damage your spa and void the manufacturer 
warranty.
Water Fill Volume by Model
Spa Model
Approximate Fill Volume
J210 .......................................220 US Gallons (833 Liters)
J220 .......................................335 US Gallons (1,268 Liters)
J230 .......................................380 US Gallons (1,438 Liters)
10.  Leave spa cover open during this step to allow exces-
sive chemical vapors to exit spa, protecting pillows and 
plastic knobs from chemical attack.  If spa is indoors, 
open doors and windows for proper ventilation.  Turn on 
all spa jet pumps for one hour, open all air controls, and 
place the Divert-A-Jet (J-210 models) or massage selec-
tor knob (J-220 models) in the center “combo” position as 
shown, (right).  Note: You will need to press the jets pump 
button(s) every 20 minutes since these functions have an 
automatic 20 minute time-out function that turns them off.
B