Jacuzzi j - 200 j - 280 User Manual

l1  Lock Out (disables all spa functions to permit filter 

cleaning)

l2  Lock Mode (disables the jets and light buttons to 

prevent unauthorized use of spa). Filtration/heating 

cycle will continue to operate as programmed in 

this mode. The temperature display flashes when this function is 

enabled. Example: the “F3” filtration/heating cycle was enabled 

prior to choosing lock mode. The spa continues to perform the 

“F3” cycle until lock mode is canceled, allowing another cycle to be 

selected.

To set a time for the first filtration/heating cycle, simply turn power on to 

the spa two minutes prior to the desired time. Example: If you desire your 

first filtration/heating cycle to begin at 10:00 AM turn off power to the spa 

and turn it back on again at 9:58 AM. 

note: Start time is approximate and may vary slightly from day to day.

this section and refer to page 29 for filter cycle programming details.

(Heater automatically turns on during any heat call while in any Standard 

mode).

F0  5 minutes of filtration per day (one 5 minute “Blow-Out” 

cycle every 24 hours to purge all plumbing lines)

F1  1 hour of filtration per day (one 30-minute cycle every 

twelve hours); this is the factory default setting.

F2  1.5 hours of filtration per day (one 30-minute cycle 

every eight hours).

F3  2 hours of filtration per day (one 30-minute cycle every 

six hours).

(Heater can only turn on during an active filter cycle while in any 

economy mode).

F4  1 hour of filtration/heating per day (one 30-minute 

cycle every twelve hours).

F5  1.5 hours of filtration/heating per day (one 30-minute 

cycle every eight hours).

F6  2 hours of filtration/heating per day (one 30-minute 

cycle every six hours).

30