Jensen BT1613 User Manual
15A
iPod
+
BT1613
PS/AS
BT1613
What’s in the Box
BT1613 Head Unit
Cosmetic Trim Ring
Wiring Harness Power/Speaker
Mounting Hardware
Remote Control
jLink iPod Cable
3.5mm Media Cable
Owners Manual
Installation Guide
Cosmetic Trim Ring
Wiring Harness Power/Speaker
Mounting Hardware
Remote Control
jLink iPod Cable
3.5mm Media Cable
Owners Manual
Installation Guide
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Tools and Supplies
You will need these tools and supplies to install your
BT1613:
BT1613:
Torx type, fl at-head and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver,
socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16 – 18 gauge speaker wire
Wire cutters and strippers
Tools to remove existing radio (screwdriver,
socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16 – 18 gauge speaker wire
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with safe driving
conditions.
conditions.
Wiring Diagram
IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have
the installation handled by an experienced technician.
the installation handled by an experienced technician.
Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.
NOTE: When replacing a
fuse, make sure the new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio. This
head unit uses one 15
amp fuse located below
the wiring connector (15
amp fast blow ATO).
fuse, make sure the new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio. This
head unit uses one 15
amp fuse located below
the wiring connector (15
amp fast blow ATO).
Power Antenna (dark blue wire) Connect
to the power antenna or an amplifi er. If not
used, tape the bare end of wire.
to the power antenna or an amplifi er. If not
used, tape the bare end of wire.
Accessory/Ignition (red wire)
Connect to the existing radio wire or radio
fuse.
Connect to the existing radio wire or radio
fuse.
Ground (black wire)
Connect to the ground terminal or a
clean, unpainted part of the chassis.
Connect to the ground terminal or a
clean, unpainted part of the chassis.
Memory/Battery (yellow wire)
Connect to the battery or to a 12 volt
power source that is always live. The radio
will not work if this wire is not connected.
Connect to the battery or to a 12 volt
power source that is always live. The radio
will not work if this wire is not connected.
Antenna
RCA Outputs to Amplifi er
Left Front Speaker
Right Front Speaker
Left Rear Speaker
Right Rear Speaker
Dark Blue
Black
Yellow
Red
Grey
Grey/Black (-)
Grey (+)
White/Black (-)
White (+)
Violet/Black (-)
Violet (+)
Green/Black (-)
Green (+)
15 Amp Fuse
SERIES
Subwoofer
Output
Output
iPod/jLink connector
Use this 8-pin DIN socket to
connect your jLink iPod cable.
Use this 8-pin DIN socket to
connect your jLink iPod cable.
jLink
iPod Cable
iPod Cable