beiter pl User Manual

A (min) mm

C

A (max) mm

Each single Plunger has a 3 to 4mm variable screw 
length "A". 

By changing single parts of it - Pin and/or slotted 
nut and/or thread cylinder - a screw-in length from 
17.5 mm up to 34.5 mm can be reached.

The available combinations are shown on the table 
on the previous page.

The Beiter Plunger is offered - according to the model - 

with a choice out of two nuts, which are allowing a different 

screw-in depth “A”.

HINTS AND MAIN FEATURES:
The Beiter Plunger has a "hard" spring mounted (0.60 mm thickness).

If during the tuning of your bow the notching scale cylinder goes close to 0 on the thread scale, 
change to the "extra hard" spring (0.70 mm thickness). This usually occurs if the arrow reacts too 
weak.

If the thread scale goes close to 10, then replace the "hard" spring with the "soft" spring (0.45mm 
thickness). This usually occurs if the arrow reacts too stiff.

Following table - included in each sold Plunger - shows how the single springs are reacting: with the 
”hard” spring (0.60) on scale position 1.0 you will reach a tensile strength of approx. 8N (Newton).
You can reach the same tensile strength with an ”extra hard” spring (0.70) on scale position 7.5.

Important: A wrong arrow (an arrow with the wrong spine) cannot be compensated by any 
plunger!