caddx nx-4 Manual
9
DISARMING YOUR SYSTEM
When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a continuous tone for the duration of the
entry delay time, or until you enter a valid code. The red
doors, the keypad control will sound a continuous tone for the duration of the
entry delay time, or until you enter a valid code. The red
armed light
will go off
and the tone will stop. The security system is now DISARMED. If a valid code is
not entered before the end of the entry delay, an alarm will occur. (NOTE: If the
red
not entered before the end of the entry delay, an alarm will occur. (NOTE: If the
red
armed light
is flashing during the entry delay, the alarm system has
been activated in your absence. Leave the building immediately and call
your alarm company and/or the police from a safe location.)
your alarm company and/or the police from a safe location.)
CANCEL / ABORT FEATURE (Optional, see page 1)
The
cancel light
will flash during an abort delay time. If a code is entered
followed by the [CANCEL] key while this light is flashing, all abortable reports will
stop the communication process. Entering a code followed by the [CANCEL] key
during or after an alarm report to the central station will cause the
stop the communication process. Entering a code followed by the [CANCEL] key
during or after an alarm report to the central station will cause the
cancel light
to
come on. It will stay on until the central station has received the cancel report.
BYPASSING ZONES
If you wish to bypass one or more zones, this must be done while the system is in
the disarmed state. The following steps are used for bypassing zones:
the disarmed state. The following steps are used for bypassing zones:
Step 1
Press the [BYPASS] key.
Step 2
Enter user code, if required (optional). The
bypass light
flashes.
Step 3
Enter the 1-digit number for the zone you wish to bypass. (Example:
Press the [1] key for zone 1, press [4] for zone 4.)
Press the [1] key for zone 1, press [4] for zone 4.)
Step 4
Press the [BYPASS] key again.
Step 5
The corresponding
zone light
will illuminate indicating the zone has
been bypassed. Repeat steps 3 and 4 for any other zone(s) that
need to be bypassed.
need to be bypassed.
Step 6
Press the [BYPASS] key again -or- press the [#] key to exit the
Bypass Mode. The
Bypass Mode. The
bypass light
will stop flashing upon exiting the
Bypass Mode.
GROUP BYPASS
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.