eutech-instruments cyberscan con 10 conductivitytds meter User Manual

49

When press PRINT key on the CyberScan CON 200 meter, the “Print” and “Err” annunciators

blink on the meter’s LCD screen as shown in Figure 53.

You have not "ENABLE CONNECTION" in the
CyberComm DAS program.

Click on "ENABLE CONNECTION" in the CyberComm
DAS program.

The "Communication Settings" in the CyberComm
DAS program is different from meter's setup.

Match the COM port number, baud rate, parity and
stop bits information between the CyberComm DAS
program and the meter.

The COM port number in the CyberComm DAS
program is wrong.

Change the COM port number (1 or 2) in the
CyberComm DAS program.

Your computer's COM port setting may be wrong.

Check  your  computer's  hardware  settings  (through
Windows OS, BIOS, or any other OS) and refer to
computer's manual or consult with the computer's
manufacturer.

You may use the wrong communication cable.

Make  sure  you  use  the  RS232C  cable  supplied
together with the meter (Part No. EC-CA01M09F09).
Check the RS232C configuration as described in the
meter's instruction manual.

When press PRINT key on the CyberScan CON 200 meter, additional characters such as the

following appear.

06/18/2001 1:48:38 PM?   Cond?   -900? Temp: ?22.6

The Baud rate, parity or stop bit information
are not matched.

Check the communication setup for both CyberComm DAS
program and meter and ensure both are the same.

To report any bugs, please e-mail to 

techsupport@eutechinst.com