lawrence dl20 lion s head assembly User Manual
TOOLS REQUIRED:
• Phillips head screwdriver, Power Drill, Wrench
• Lion’s Head Bracket with accompanying
hardware (tech screw, threaded rod, wood screw,
washer and nut)
• 2 “ Tube railing
• Duralit Brass Polish
• A clean rag (to clean off fingerprints)
• Lion’s Head Bracket with accompanying
hardware (tech screw, threaded rod, wood screw,
washer and nut)
• 2 “ Tube railing
• Duralit Brass Polish
• A clean rag (to clean off fingerprints)
INSTRUCTIONS:
Step 1
Insert threaded rod into threaded hole located in
back of the Lion’s Head Bracket.
Insert threaded rod into threaded hole located in
back of the Lion’s Head Bracket.
Step 2
Pre drill hole for 3/8” threaded rod and position
Lion’s Head in place. If threaded rod is exposed
through underside of bar add washer and tighten
nut into place using a wrench.
Pre drill hole for 3/8” threaded rod and position
Lion’s Head in place. If threaded rod is exposed
through underside of bar add washer and tighten
nut into place using a wrench.
Step 3
Insert Wood screw into pre-drilled pilot hole
through the front of the bar to complete Lion’s
Head bracket installation.
Insert Wood screw into pre-drilled pilot hole
through the front of the bar to complete Lion’s
Head bracket installation.
Step 4
Insert railing through Lion’s bracket and position
Insert railing through Lion’s bracket and position
Step 5
Insert tech screw into the bottom of Lion’s bracket
to secure railing into position.
Insert tech screw into the bottom of Lion’s bracket
to secure railing into position.
Lion’s Head (DL20) Bar Assembly
Step 1
Step 2
Step 3
Step 4
Lawrence Metal Products Inc. • 800.441.0019 • 631.666.0300 • Fax: 631.666.0336 • www.lawrencemetal.com
e-mail: service@lawrencemetal.com • PO Box 400-M • 260 Spur Drive South, Bay Shore, New York 11706-0779 USA
Step 5