husky-liners 56731 User Manual
PART NO.
5673
5673 Tahoe Front (2 S#94421.doc
Rev: 0
TAHOE, SUBURBAN FRONT MUD GUARD
INSTALLATION INSTRUCTIONS
Install paint protection film before mud guard (see other side).
Please read instructions thoroughly before installation.
Install paint protection film before mud guard (see other side).
Please read instructions thoroughly before installation.
Tools Required:
•
Center punch / Hammer
•
Short Phillips screwdriver or drill attachment
•
Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
•
•
Driver & passenger side mud guard
•
#10 screw (4)
•
Washers (4)
•
U-clip (4)
•
Paint Protection Film (1set)
•
Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fasteners from locations A and B (Figure 1).
3. Attach mud guard to front fender with “existing factory fasteners” at locations A and B. Check fit and parallel and adjust
2. Remove existing fasteners from locations A and B (Figure 1).
3. Attach mud guard to front fender with “existing factory fasteners” at locations A and B. Check fit and parallel and adjust
accordingly before tightening.
4. Remove existing plastic fasteners from locations C and D and install U-clips over fender holes.
5. Install #10 screws and washers at locations C and D.
5. Install #10 screws and washers at locations C and D.
Figure 1
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer