husky-liners 5625fr User Manual

                                                                          

5625 Front Instructions (2 SIDE

Rev: 2

•

 

1/8” drill bit / Drill

•

 

Center punch / Hammer

•

 

Short Phillips screwdriver or drill attachment

•

 

Flat head screwdriver

•

 

Marking utensil (fine tip marker, grease pencil, etc.)

•

 

Driver (LH) & passenger (RH) side mud guards

•

 

#10 screw (qty. 6)

•

 

U-Clip (qty. 4)

•

 

Fender Washer (qty. 2)

•

 

Instruction sheet

•

 

Paint Protection Film

NOTE:  Turn the front wheels all the way to the left or right for mud guard installation.  However, it may be necessary
              to remove the wheels depending on the tools being used for installation.

1.  Clean and degrease the mud guard location area on the fender before installation.
2.  Remove existing plastic rivets from locations A, B, and C by prying insert (1) out of sleeve (2) with a flat tip screwdriver and

removing the sleeve (2) (Figure 1 and 2).

3.  Pull the fender liner back and slide a U-Clip over locations C and D (Figure 1 and 3).
            NOTE: the upper factory fender hole will not be used.
4.  Reinstall fender liner with existing plastic rivets at locations A and B (LINER SHOULD NOT OVERLAP MUD GUARD).
5.  Attach mud guard at location D with a #10 screw.  Adjust accordingly before tightening screw.
6.  Center punch and drill a 1/8” hole at location E and fasten with a #10 screw.
7.  Install a fender washer and #10 screw at location C.

NOTE:  MUD GUARD WAS DESIGNED TO USE FACTORY FENDER HOLES WHERE POSSIBLE.  If holes do not line up, place
mud guard against fender, mark new hole locations onto the mud guard and drill a _” hole through mud guard.

1.  Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.  Sand painting surface with 320 grit sand paper.
3.  Apply a coating of flexible primer-adhesion promoter.
4.  Apply a flexible paint as directed by the paint manufacturer