husky-liners 57701 User Manual
PART NO.
5770
5770 Rear Instruction#109BC.doc
Rev: 0
CHEVROLET / GMC COLORADO / CANYON
WITHOUT FENDER FLARES
WITHOUT FENDER FLARES
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Please read instructions thoroughly before installation.
Tools Required
•
•
1/8” drill bit / Drill
•
Short #2 Phillips screwdriver
•
Center punch
Package Contents
•
Driver & passenger side rear mud guard
•
#10 screw (qty. 8)
•
Washers (qty. 8)
•
U-Clip (qty. 2)
•
Paint Protection Film (1 set)
•
Instruction sheet
NOTE:
It may be necessary to remove the rear wheels for mud guard installation.
1.
Clean and degrease the mud guard location area on the fender before installation.
2. Install u-clip over sheet metal at location D and align with existing hole (Figure 1).
3. Attach mud guard with #10 screw and washer at location D, check fit and make sure the mud guard is parallel to
3. Attach mud guard with #10 screw and washer at location D, check fit and make sure the mud guard is parallel to
the ground before tightening.
4. Using the mud guard as a template, center punch and drill 1/8” holes at locations A, B, and C (Figure 1).
5.
Install #10 screws and washers at locations A, B, and C.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.