Audioengine D2R Owner's Manual

D2 setup guide

8

Pairing is the function by which two devices become acquainted.  Once 
a Sender and Receiver(s) are paired, they will remember one another.  

Note:  D2 Senders and Receivers packaged together are paired out 
of the box, so if you’re only using one Sender/Receiver set, no further 
configuration is needed.

To pair an additional Receiver or to re-pair a Sender/Receiver set, press 
the Pair button on the Receiver (the Pair LED will blink), then press the 
Pair button on the Sender.  Both Sender and Receiver pair lights should 
now be solid, indicating that they are paired.

•  I have connected my D2 Sender and Receiver as shown, but there is 

no music output.

1.  Check to see that the Power and Pair lights are lit and solid.  If 

not, try another USB port on your computer.

2.  If the Pair light is blinking re-pair the Sender and Receiver as 

discussed in the Pairing section.

3.  Verify that “Audioengine D2” is selected as your output device 

under Control Panel (PC) or System Preferences/Audio (Mac).

4.  Try another USB cable.

5.  Verify that the proper input source is selected on your audio 

system.

•  I have connected my D2 to my TV/DVD/BluRay, but there is no sound 

output.

1.  Verify that the D2 Sender and Receiver are both connected to a 

power adapter and that the power lights are lit.

2.  Be sure that your source digital audio is set to “PCM Stereo”.