AudioControl Epicenter® 1200 Owner's Manual
18
Installation Manual
1. Fuses
40A – There are two fuses on Epicenter 600, and three on
the Epicenter 1200 as shown. Replace the fuses only with the
exact same style and Ampere rating. Disconnect 12V power be-
fore changing or inspecting the fuses.
exact same style and Ampere rating. Disconnect 12V power be-
fore changing or inspecting the fuses.
2. Power Input Terminal +12V – This screw terminal connects to
the +12V battery binding post of the vehicle. Use quality insulated
wiring of the recommended wire gauge, such as wire gauge 4 or
thicker. Thinner wire may cause an overheating hazard due to the
large currents involved.
wiring of the recommended wire gauge, such as wire gauge 4 or
thicker. Thinner wire may cause an overheating hazard due to the
large currents involved.
3. Remote Power Input Terminal – This screw terminal connects
to the 12V remote trigger output of some head units. When the
head unit is turned on, then the Epicenter amplifier will turn on.
Alternatively, you can use the GTO feature of the amplifier so it
will turn on when an audio signal is detected at the speaker-level
or line-level inputs.
head unit is turned on, then the Epicenter amplifier will turn on.
Alternatively, you can use the GTO feature of the amplifier so it
will turn on when an audio signal is detected at the speaker-level
or line-level inputs.
4. Power Input Terminal Ground – This screw terminal connects to
a good ground connection on the vehicle.
Connection Panel
Features
1
2
3
4
5
6 7
8
9
Chapter 5: Features