AudioControl LC-6.1200 Owner's Manual

Quick Start Guide

The AudioControl ACR-1 dash control is a remote level for your 
LC-6.1200 amplifier. It may be mounted under the dash using its own 
enclosure, or through a custom hole in the dash. The knob should 
be within reach of the driver, and in a spot where the LED is plainly 
visible. Disconnect the vehicle battery +12V and Ground connections 
before installation.

Dash Bracket Installation: The dash control mounts with four 

screws, which attach to the underside of the dashboard. Slide 
under the dash and place the dash control in its mounting po-
sition, mark the best mounting holes, carefully drill pilot holes, 
and secure with screws.

Custom Installation: For that custom, finished look, the dash control 

can be flush-mounted directly on the dashboard (or anywhere 
else). Disassemble the ACR-1 from its enclosure.

The top lid must be removed to gain access to the controls, and then 
put back on again to protect the controls from dust bunnies.

1.  Locate the two screws that hold the straight edge of the lid onto 

the connector side of the amplifier. 

2.  Use the supplied hex key to loosen both screws just enough 

until this edge of the lid can lift freely up just a little. (There is no 
need to remove the screws all the way, in case you lose them.)

3.  Slide the lid toward the heatsink fins just a tad, before further 

lifting the straight edge of the lid about 2”, then disengage the 
remaining two points of contact (under the wavy edge).

4.  Place the lid in a safe and handy place, ready for the time when 

you have finished adjusting the controls to your immense satis-
faction, and just before Chivers brings tea and sandwiches.