AudioControl EQX Owner's Manual
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
ä HIGH PASS OUTPUT – RCA jacks for connec-
tion of high frequencies above the crossover
point to the inputs of the mid/high fre-
quency amplifier.
point to the inputs of the mid/high fre-
quency amplifier.
ä LOW PASS OUTPUT – RCA jacks for connec-
tion of low frequencies below the crossover
point to the inputs of the low frequency
amplifier.
point to the inputs of the low frequency
amplifier.
ä LOW PASS MONO NORMAL/INVERT – RCA
jacks for connection of mono low
pass signals below the crossover point for
mono or bridged amplifier configurations.
pass signals below the crossover point for
mono or bridged amplifier configurations.
ä REMOTE/+12/GROUND - Our handy 3 pin
plug for power connection of vehicle’s
Remote Turn-On, +12 Volts, and Power
Ground.
Remote Turn-On, +12 Volts, and Power
Ground.
Crossover/Programmable Frequency
Match Modules and Ground Isolation
Selector (Inside)
Match Modules and Ground Isolation
Selector (Inside)
The crossover and PFM filter modules, as well as
the ground isolation selector, are internal and
can be accessed by removing the four top screws
and lifting the top panel off the base (refer to
Figure 8 on page 20). Be sure to turn off the
power before you open the EQX.
the ground isolation selector, are internal and
can be accessed by removing the four top screws
and lifting the top panel off the base (refer to
Figure 8 on page 20). Be sure to turn off the
power before you open the EQX.
We ship each EQX with the crossover installed
at 90 Hz and the Programmable Frequency
Match filter set at 33 Hz. Refer to page 18 for
information on how to create your own custom
crossover and PFM modules.
at 90 Hz and the Programmable Frequency
Match filter set at 33 Hz. Refer to page 18 for
information on how to create your own custom
crossover and PFM modules.
Description
7