Ingenico BAS930P User Manual
4.3.
Installing Modules
4.3.1.
SAM1/SAM2
WARNING
Switch off the terminal by disconnecting the power supply.
Switch off the terminal by disconnecting the power supply.
The connector modules security SAM are located inside the terminal,
in a closed compartment.
in a closed compartment.
•
Turn the terminal and unclip the top cover flap by pushing
on the clips with your nails as shown with the arrows on the
picture
picture
•
SAM1 and SAM2 are indentified by the engraved marks on
the lower housing
•
When introducing a SAM in its slot, be sure to put the
cut corner as indicated on the picture
•
Close the cover flap
TIP
Use a piece of adhesive tape to grip the SAM for easier and
faster removal.
Use a piece of adhesive tape to grip the SAM for easier and
faster removal.
4.3.2.
SAM3/SAM4 or SIM
WARNING
Switch off the terminal prior to inserting the modules
•
Open the lower cover flap, by pushing on the clips with
your nails as shown on the picture
•
SAM3 and SAM4 or SIM are indentified by the engraved
marks on the lower housing
•
When introducing a SAM in its slot, be sure to put the
cut corner as indicated on the picture
For easier introduction the cut corner is also indicated with an
engraved marks on the lower housing
Close the cover
TIP
Use a piece of adhesive tape to grip the SAM for easier and
faster removal.
Use a piece of adhesive tape to grip the SAM for easier and
faster removal.
Cut corner
position
position
Cut corner
position
position