Ingenico BAS930P User Manual

Page of 35
 
 
Electrical power outlet 
 
The electrical outlet must meet the following criteria:   
• 
Must be installed near the equipment and easily accessible; 
• 
Must meet standards and regulations in the country where used; 
• 
For type A plug, the protection of the installation must be set to 20 A. 
Telephone network 
 
The  phone  jack  must  comply  with  standards  and  regulations  in  the  country  where 
used. 
SAM1 and SAM2 readers compartment 
 
The cover flap for battery, SAM1 and SAM2 readers located underneath the terminal, 
must be in place during the normal operation of the terminal. See sections "Removal 
of SAM1 and SAM2 modules" as well as "Connecting the battery".  
Cover flap for Second Card Reader, SAM3 and SAM4 (or SIM) readers 
 
The cover flap for the Second Card Reader, SAM3 and SAM4 (or SIM), located on the 
underside  of  the  terminal  must  be  in  place  during  normal  operation.  See  section 
"Removal of SAM3 and SAM4 (or SIM) modules".  
On airplanes 
 
Your  handset  must  be  switched  off  by  removing  the  battery  pack.  Remove  the 
battery from the terminal when on an airplane. 
 
Non-compliance  with  these  safety  rules  may  result  in  legal  action  and/or  a  ban  on 
later access to cellular network services. 
Explosion areas 
 
Certain regulations restrict the use of radio equipment in chemical plants, fuel depots 
and  any  site  where  blasting  is  carried  out.  You  are  urged  to  comply  with  these 
regulations.  The  terminal shall  be  protected  by  a  specially  fitted  and  certified  cover 
enabling use in proximity to a fuel pump. 
Electronic health appliances 
 
Your handset is a radio transmitter which may interfere with health appliances, such 
as hearing aids, pacemaker, hospital equipment, etc. 
Your  doctor  or  the  equipment  manufacturer  will  be  able  to  provide  you  with 
appropriate advice. 
 
 
6.2. 
Telephone call 
You have an urgent call to make while the EFT930 is occupying the line. 
In order to get a dial tone: 
 
Place the handset in the hang up position and:  
press the red key (=cancel) 
or 
disconnet the power supply from the mains network 
or 
disconnet the EFT930 telephone connector from the telephone call socket, and 
place the telephone connector into the telephone wall socket. 
 
You hear a dial tone within 6 seconds.