Ingenico IWL2XXBCL User Manual
iWL2xx Wireless Series
•
15/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
4.5.
Battery
4.5.1.
Main characteristics
Characteristics
Li-ion
Capacity
2050mAh
Charge
50% capacity in 1.5h; full capacity
in 4hours
in 4hours
Autonomy*
500 typical transactions
up to 250h in stand by
up to 250h in stand by
* depend on the terminal type and its base.
4.5.2.
Installing the battery
WARNING
Switch off the terminal prior to connecting the battery.
Switch off the terminal prior to connecting the battery.
•
Turn your terminal and unclip the battery trapdoor by
pushing on the clips with your nails as shown on the
picture
pushing on the clips with your nails as shown on the
picture
•
Disengage the trapdoor
•
Take the battery pack included in the box
•
Locate the battery pack connector beside the battery
compartment
compartment
•
Plug the battery pack connector according to the
connector locating system and the red wire (as
shown on picture).
Verify that it locks.
connector locating system and the red wire (as
shown on picture).
Verify that it locks.
•
Place the battery pack in its compartment.
•
Check that the wires’ path is flat
•
Close the battery compartment trapdoor.
Red wire
Battery compartment
iWL2xx Wireless Series
•
16/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
4.5.3.
Charging the battery
When does the battery need to be charged?
•
On initial start up, charge the battery for 16 hours under the environmental
conditions stated above
•
When used daily, the terminal recharges its batteries each time it is placed on its
base or each time the traveller charger is connected. Charging is automatic
How does the battery need to be charged?
•
The environment in which the charge takes place influences battery lifetime and
autonomy (number of transactions)
autonomy (number of transactions)
The optimal conditions are as follows:
Charging away from any external heat source (radiator, sun, enclosed area…)
The optimal temperature is between +15°C and +25°C
How can the battery be charged?
Using the base
•
Place the terminal on its base
•
Check if the battery symbol is flashing or moving (=battery charging).
Using the power travel adapter (the terminal is out of its base)
•
Connect the traveller power supply unit to the terminal microAB connector located
on the left side of the terminal.
on the left side of the terminal.
•
Connect the power supply unit to the power supply mains network
•
Check if the battery symbol is flashing or moving(=battery charging)