Contec DS110-APL User Manual
Settings
FX-DS110-APL
35
To Register or Set Up a New Access Point
(1) Start the utility software. From the main menu, select Edit,
and use Search to find the desired APL.
If the access point name has not been set up, the MAC address
and IP address will be displayed. Assigning an access point
name will make the access point easier for the network to
identify.
and IP address will be displayed. Assigning an access point
name will make the access point easier for the network to
identify.
(2) From the main menu, select Configuration, then use the Base
tab to enter the appropriate settings for the network
environment (IP address, network mode, data scramble, ESS
ID, transmit rate, channel).
environment (IP address, network mode, data scramble, ESS
ID, transmit rate, channel).
Also, enter any necessary settings on the SNMP and Spanning
Tree tabs.
Tree tabs.
*Note that the spanning tree can only be used when the
network mode is ADHOC' mode.
network mode is ADHOC' mode.
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.
To Edit Settings for an Existing Access Point
(1) Start the utility software. From the main menu, select
Configuration, and then select the access point you wish to edit
from the access point name list.
from the access point name list.
*Once an APL on the network has been located using Search,
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
(2) Edit the settings as desired.
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.