Buffalo 06197952-0 User Manual
following conditions:
1) The antenna must be installed such that 20 cm is maintained
1) The antenna must be installed such that 20 cm is maintained
between the antenna and users, and
2) The transmitter module may not be co-located with any other
transmitter or antenna, and
3) The antenna should be integral if the end device is intended to be
operated in 5.15 ~ 5.25GHz frequency range.
As long as 3 conditions above are met, further transmitter test will not
be required. However, the OEM integrator is still responsible for
testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be
met (for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product.
In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
be required. However, the OEM integrator is still responsible for
testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be
met (for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product.
In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the
antenna may be installed such that 20 cm may be maintained
between the antenna and users (for example : Access point,
antenna may be installed such that 20 cm may be maintained
between the antenna and users (for example : Access point,
Router…mobile device.). The final end product must be labeled in a
visible area with the following: “Contains TX FCC ID:
visible area with the following: “Contains TX FCC ID:
FDI-06197952
”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information
to the end user regarding how to install or remove this RF
module in the users manual of the end product which integrate
this module.
The users manual for end users must include the following
information in a prominent location “ IMPORTANT NOTE: To comply
with FCC RF exposure compliance requirements, the antenna used
for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter”.
If the end product integrating this module is going to be operated in
5.15 ~ 5.25GHz frequency range, the warning statement in the user
manual of the end product should include the restriction of operating
this device in indoor could void the user’s authority to operate the
information in a prominent location “ IMPORTANT NOTE: To comply
with FCC RF exposure compliance requirements, the antenna used
for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter”.
If the end product integrating this module is going to be operated in
5.15 ~ 5.25GHz frequency range, the warning statement in the user
manual of the end product should include the restriction of operating
this device in indoor could void the user’s authority to operate the