Buffalo 09101695-0 User Manual
Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one of the following measures:
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be op-
erated. Selection of other channels is not possible. This device and its antenna(s)
must not be co-located or operation in conjunction with any other antenna
or transmitter. This device is going to be operated in 5.15~5.25GHz frequency
range, it is restricted in indoor environment only.
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be op-
erated. Selection of other channels is not possible. This device and its antenna(s)
must not be co-located or operation in conjunction with any other antenna
or transmitter. This device is going to be operated in 5.15~5.25GHz frequency
range, it is restricted in indoor environment only.
Important Note - FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an un-
controlled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands
are country dependent and are firmware programmed at the factory to match
the intended destination. The firmware setting is not accessible by the end user.
controlled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands
are country dependent and are firmware programmed at the factory to match
the intended destination. The firmware setting is not accessible by the end user.
Industry Canada statement:
Industrie Canada déclaration:
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable
aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage sus-
ceptible de provoquer un fonctionnement indésirable.
Canada.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable
aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage sus-
ceptible de provoquer un fonctionnement indésirable.
Caution:
Prudence:
The device for the band 5150-5250 MHz is only for indoor usage to reduce po-
tential for harmful interference to co-channel mobile satellite systems.
tential for harmful interference to co-channel mobile satellite systems.
Le dispositif fonctionnant dans la bande 5150-5250 MHz est réservé unique-
ment pour une utilisation à l’intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
ment pour une utilisation à l’intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
The maximum antenna gain permitted for devices in the band 5725-5825 MHz
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-
point operation as appropriate.
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-
point operation as appropriate.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
operated. Selection of other channels is not possible.
The device could automatically discontinue transmission in case of absence of
information to transmit, or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
information to transmit, or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
Important Note - Radiation Exposure Statement:
Note Importante - Déclaration d’exposition aux radia-
tions:
This equipment complies with IC radiation exposure limits set forth for an un-
controlled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This device has been designed to operate with an antenna having a maximum
gain of [4.33] dB. Antenna having a higher gain is strictly prohibited per regula-
tions of Industry Canada. The required antenna impedance is 50 ohms.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for success-
ful communication.
controlled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This device has been designed to operate with an antenna having a maximum
gain of [4.33] dB. Antenna having a higher gain is strictly prohibited per regula-
tions of Industry Canada. The required antenna impedance is 50 ohms.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for success-
ful communication.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être in-
stallé et utilisé avec un minimum de 20 cm de distance entre la source de ray-
onnement et votre corps.
Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain max-
imal de dB [4.33]. Une antenne à gain plus élevé est strictement interdite par les
règlements d’Industrie Canada. L’impédance d’antenne requise est de 50 ohms.
Conformément à la réglementation d’Industrie Canada, le présent émetteur
radio peutfonctionner avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pourl’émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectriqueà l’intention des autres utilisateurs, il
faut choisir le type d’antenne et son gain de sorte que lapuissance isotrope ray-
onnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire àl’établissement
d’une communication satisfaisante.
établies pour un environnement non contrôlé. Cet équipement doit être in-
stallé et utilisé avec un minimum de 20 cm de distance entre la source de ray-
onnement et votre corps.
Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain max-
imal de dB [4.33]. Une antenne à gain plus élevé est strictement interdite par les
règlements d’Industrie Canada. L’impédance d’antenne requise est de 50 ohms.
Conformément à la réglementation d’Industrie Canada, le présent émetteur
radio peutfonctionner avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pourl’émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectriqueà l’intention des autres utilisateurs, il
faut choisir le type d’antenne et son gain de sorte que lapuissance isotrope ray-
onnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire àl’établissement
d’une communication satisfaisante.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC. The following test methods have been applied in order to prove pre-
sumption of conformity with the essential requirements of the R&TTE Directive
1999/5/EC:
1999/5/EC. The following test methods have been applied in order to prove pre-
sumption of conformity with the essential requirements of the R&TTE Directive
1999/5/EC:
EN60950-1: 2006 +A11: 2009
Safety of Information Technology Equipment
Safety of Information Technology Equipment
EN50385 : (2002-08)
Product standard to demonstrate the compliance of radio base stations and
fixed terminal stations for wireless telecommunication systems with the basic
restrictions or the reference levels related to human exposure to radio frequen-
cy electromagnetic fields (110MHz - 40 GHz) - General public
Product standard to demonstrate the compliance of radio base stations and
fixed terminal stations for wireless telecommunication systems with the basic
restrictions or the reference levels related to human exposure to radio frequen-
cy electromagnetic fields (110MHz - 40 GHz) - General public
EN 300 328 V1.8.1: (2012-04)
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband
Transmission systems; Data transmission equipment operating in the 2,4 GHz
ISM band and using wide band modulation techniques; Harmonized EN cover-
ing the essential requirements of article 3.2 of the R&TTE Directive
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband
Transmission systems; Data transmission equipment operating in the 2,4 GHz
ISM band and using wide band modulation techniques; Harmonized EN cover-
ing the essential requirements of article 3.2 of the R&TTE Directive
EN 301 893 V1.7.0: (2012-01)
Broadband Radio Access Networks (BRAN); 5 GHz high performance RLAN;
Harmonized EN covering the essential requirements of article 3.2 of the R&TTE
Directive
Broadband Radio Access Networks (BRAN); 5 GHz high performance RLAN;
Harmonized EN covering the essential requirements of article 3.2 of the R&TTE
Directive
Regulatory Compliance Information