Buffalo 09101896-0 User Manual

  Time Settings 

o

  Choose your time zone. 

  Click “Save“. 
 
Wireless -> Basic Settings 

  Enter your country in “Regulatory Domain” 
  In the “Antenna Gain“ field, please enter the gain of your 

AirStation’s antenna. The firmware will adjust the transmit power 
automatically to meet regulatory requirements. Please note that the 
use of a long extension cable for your antenna will reduce the 
usable antenna gain. 

  Configure “Wireless Mode“ to “Client“. 
  Configure “Wireless Network Mode” to match the capabilities of the 

access point you want to connect to. 

  Enter the network name (SSID) of the AP you want to connect to into 

“Wireless Network Name (SSID)”. 

  Click “Save“. 

Wireless -> Wireless Security 
  Configure the security mode to match the security settings of the 

access point you want to connect to.  

  Click “Apply Settings“. 
 

After the router reboots, please confirm that it has connected to the 
access point. If there is a DHCP server available on the access point 
side, and the router is configured to request an IP address, then it 
should receive an IP address for its WAN-side interface. 

 

 

You can now either connect wired clients to the access point or 
configure another wireless network interface as an access point to 
grant access to wireless clients. 

 

A wireless client bridge offers the ability to transparently integrate 
the router’s LAN into a different LAN that another access point is 
connected to. Clients connected to such a router can access devices in 
both LANs and vice versa. In that configuration the router’s WAN 
interface is disabled.  

 

- 21 -