Buffalo 09101912-0 User Manual
Chapter 5 Connect to a Wireless Network
111
Maximizing the Performance of Your Wireless Network
To enable 450 Mbps communication, you’ll need a wireless client that supports 3x3 802.11n, such as
the Intel Centrino Ultimate-N 6300.
In the example below, we’ll set up the AirStation to work with a computer using the Intel Centrino
Ultimate-N 6300.
the Intel Centrino Ultimate-N 6300.
In the example below, we’ll set up the AirStation to work with a computer using the Intel Centrino
Ultimate-N 6300.
Note: After the settings below are made, the AirStation will perform communication using twice the normal
bandwidth. As a result, if there are other wireless LAN access points or a large number of devices using
2.4GHz band signals in the vicinity of the AirStation, signal interference may occur, resulting in reduced
performance.
2.4GHz band signals in the vicinity of the AirStation, signal interference may occur, resulting in reduced
performance.
If this type of interference is observed, either change the wireless channel of the access point, or turn off
any devices that are not being used.
any devices that are not being used.
Setting the AirStation
1
Open the configuration interface (chapter 4).
2
In Easy Setup, click [Wireless SSID & Channel (11n
450 Mbps Mode)].
450 Mbps Mode)].
3
Change the value in 450 Mbps
Mode - Bandwidth to “40 MHz”,
then click [Apply].
Mode - Bandwidth to “40 MHz”,
then click [Apply].