Buffalo 09101938-0 User Manual

WCR-G300 / WCR-HP-G300 User Manual

Chapter 6 Trouble Shooting

Cannot connect to the network wirelessly.

•

Configure your wireless device with the same SSID, encryption type, and encryption key as used
by your AirStation.

The factory defaults are:

SSID -

The AirStation’s MAC address (printed on the label)

Encryption Type -

WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or

WPA2-PSK AES).

Encryption Key -

Printed on the label of the AirStation.

Note: Encryption is disabled by default in Asia Pacific.

• Place your AirStation and wireless devices 2 - 10 feet apart.

• Restart your AirStation.

You forgot AirStation's SSID, Encryption Key, or

Password.

Hold down the Reset button (page 106) on your AirStation for 5 seconds to initialize its settings. All
settings, including your password, SSID, and encryption key will be initialized to their defaults.
The followings are the factory default settings of the AirStation.

SSID -

The AirStation’s MAC address (printed on the label)

Encryption Type -

WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or

WPA2-PSK AES).

Encryption Key -

Printed on the label of the AirStation.

(Encryption is disabled by default for Asia Pacific AirStations.)

The link speed is slower than 150 Mbps (Maximum

link speed is only 72Mbps).

By default, the AirStation’s 150 Mbps mode is not enabled. To enable it, use the following procedure:

1. Open the configuration interface of your AirStation (page 23).

2. Click [Wireless SSID & Channel (11n 150Mbps Mode)] in Easy Setup.

3. Change the value in [150 Mbps Mode] - [Band Width] to 40 MHz and click [Apply].

If you still cannot connect at 150 Mbps, check the settings of your wireless client device.