Buffalo 09102002-0 External Photos
REPORT NO: 06J10094-10
DATE: March 2, 2006
FCC ID: FDI-09102002-0
COMPLIANCE CERTIFICATION SERVICES
Page: 17 of 39
This report shall not be reproduced except in full, without the written approval of CCS.
7
PROCEDURE USED TO ESTABLISH TEST SIGNAL
The following procedures had been used to prepare the EUT for the SAR test.
The client provided a special driver and program, ART v53 build 5, which enable a user to control the
The client provided a special driver and program, ART v53 build 5, which enable a user to control the
frequency and output power of the module.
The cable assembly insertion loss of 20.01 dB (including 19.81dB pad and .02 dB connectors) was
entered as an offset in the power meter to allow for direct reading of power.
The cable assembly insertion loss of 20.01 dB (including 19.81dB pad and .02 dB connectors) was
entered as an offset in the power meter to allow for direct reading of power.
The cable assembly insertion loss of 20.06dB (including 19.86 dB pad and 0.2 dB connectors) was
entered as an offset in the power meter to allow for direct reading of power.
b mode
Channel
Frequency
Power
(MHz)
(dBm)
Low
2412
13.52
Middle
2437
13.94
High
2462
13.65
g mode
Channel
Frequency
Power
(MHz)
(dBm)
Low
2412
16.16
Middle
2437
16.12
High
2462
16.03
g turbo Mode
Channel
Frequency
Power
(MHz)
(dBm)
Middle
2437
18.32
a mode
Channel
Frequency
Power
(MHz)
(dBm)
Low
5180
8.70
Middle
5260
8.86
High
5320
8.71
a mode turbo
Channel
Frequency
Power
(MHz)
(dBm)
Low
5210
8.80
Middle
5250
8.92
High
5290
8.85