Buffalo 000000019 User Manual
40
Refer to the example below (if network is on 192.168.11.0).
DHCP - Disabled
IP address - 192.168.11.222
Subnet mask - 255.255.255.0
Default gateway - 192.168.11.1
WINS server - 0.0.0.0
DHCP - Disabled
IP address - 192.168.11.222
Subnet mask - 255.255.255.0
Default gateway - 192.168.11.1
WINS server - 0.0.0.0
Note: Only assign the print server a valid IP address, otherwise Settings cannot be accessed. If you cannot open
Settings, initialize the print server, which restores all settings to factory default.
Settings, initialize the print server, which restores all settings to factory default.
4
When “Restart the print server to save the settings. Restart now?” is displayed, click OK.
Switch from Wired to Wireless Connection
Follow the procedure below to switch wired connection to wireless connection.
There are 2 ways to do it: selecting from the wireless network list, or PIN method.
There are 2 ways to do it: selecting from the wireless network list, or PIN method.
Notes:
• Wired connection and wireless connection cannot be used at the same time.
• WPA2-PSK (TKIP) is not supported.
• Wired connection and wireless connection cannot be used at the same time.
• WPA2-PSK (TKIP) is not supported.
Select Wireless Access Point from List
Before starting, the print server’s connection method should be set to ‘Auto’. The access point should also have SSID
broadcast enabled and is not using WPA2-PSK (TKIP) encryption. Refer to Chapter 4 for more information.
broadcast enabled and is not using WPA2-PSK (TKIP) encryption. Refer to Chapter 4 for more information.
1
Open print server Settings and log in.
2
Navigate to Network - Wireless LAN.