Buffalo 000000019 User Manual
43
Connect by WPS PIN
Before starting, check that the connection method is auto.
1
Before starting, the print server’s connection method should be set to ‘Auto’. The target access point should have its
WPS screen open.
WPS screen open.
2
Navigate to Network - Wireless LAN - WPS Settings.
3
Note the displayed PIN, then click Execute WPS.
4
Within 2 minutes, register the PIN with the target access point.
5
Confirm that “WPS Success” is displayed. If the following window is not displayed, the connection could not be
established. Try again.
established. Try again.
6
Disconnect the Ethernet cable from the print server.
7
Disconnect the AC adapter, wait for about 10 seconds, then reconnect the AC adapter.