Omnitron iConverter RS232 8763-2-Z Leaflet
Product codes
8763-2-Z
iConverter
iConverter
®
Managed Serial RS-232 to fiber media converter with
■
automatic baud rate detection
Supports baud rates ranging from 110 to 921,600 baud
■
Supports multimode, single-mode and single-fiber with
■
ST, SC, LC and MT-RJ connectors
Supports distances up to 5km on multimode and 120km
■
on single-mode
Supports DB-9 and Terminal Block connector options
■
for serial RS-232 interface
DIP-switch configuration of DTE or DCE device for easy
■
connection to serial devices
Supports RTS, CTS, DCD, DTR and DSR controls
■
Features remote fiber loopback switch for easy testing
■
of fiber link, even during serial transmission
Management is available with the addition of a
■
management module to the chassis
SNMP management via
■
NetOutlook
®
provides real-
time port and module information, remote parameter
configuration and trap notification
Modules are hot-swappable in 19-Module, 5-Module,
■
2-Module or 1-Module chassis
Lifetime Warranty and free 24/7 Technical Support
■
iConverter
RS232
Managed Serial RS-232 to Fiber Media Converter
The Omnitron iConverter RS232 is a managed serial RS-232 to
fiber converter that transmits serial protocol over fiber media.
Fiber transmission extends the serial signals up to 120km, and
is immune from electrical and magnetic interference.
The RS232 supports single-mode, multimode, and single-fiber.
The RS232 supports single-mode, multimode, and single-fiber.
The serial port interface is available with either a DB-9 female
connector or terminal block connector for field wiring.
The RS232 automatically detects the signal baud rate of the
The RS232 automatically detects the signal baud rate of the
connected serial device, ranging from 110 to 921,600 baud.
It also automatically adjusts to changes in the connected
device’s baud rate during operation without reconfiguration
or interruption of service.
Connection to DTE or DCE devices is configured by an easily
Connection to DTE or DCE devices is configured by an easily
accessible DIP-switch on the front-panel of the module. This
feature eliminates the need to use a null-modem cable when
connecting two serial devices of the same type.
A built-in Fiber Loopback DIP-switch provides easy validation of
A built-in Fiber Loopback DIP-switch provides easy validation of
the entire fiber segment without interrupting fiber operations.
iConverter RS232 modules are hot-swappable and can be
iConverter RS232 modules are hot-swappable and can be
mounted in a 19-Module (2U high) or 5-Module (1U high) rack-
mountable chassis (19-inch or 23-inch) with any combination
of redundant AC, 24VDC or 48VDC power supplies. They
can also be mounted in a 2-Module AC or 18 to 60VDC
powered chassis, or in a 1-Module AC/DC powered chassis.
The iConverter family of managed fiber access media
converters are used in Service Provider access networks and
Enterprise LANs. iConverter media converters provide fiber
connectivity with copper to fiber, multimode fiber to single-mode
fiber, or dual fiber to single-fiber conversions.
Key Features