ICOM 316101 User Manual
-12-
3-2 Wireless Setup
Radio Settings:
Operating Mode:
There are three different wireless modes to operate, Base Station, CPE,
and Peer-to-Peer.
The default is “Base Station”.
Basically, the Multi-Client mode and LAN-to-LAN mode all are used to support multiple
devices to access internet through CPEs. But Multi-Client mode only supports IP packet, and
LAN-to-LAN supports any Ethernet protocol.
If the Base Station supports LAN-to-LAN capability(this firmware embedded), then the CPEs
which connect to that Base Station could be configured to Multi-Client mode or LAN-to-LAN
mode.
If the Base Station doesn't support LAN-to-LAN capability(old firmware embedded), then the
CPEs which connect to that Base Station should be configured to Multi-Client mode.
devices to access internet through CPEs. But Multi-Client mode only supports IP packet, and
LAN-to-LAN supports any Ethernet protocol.
If the Base Station supports LAN-to-LAN capability(this firmware embedded), then the CPEs
which connect to that Base Station could be configured to Multi-Client mode or LAN-to-LAN
mode.
If the Base Station doesn't support LAN-to-LAN capability(old firmware embedded), then the
CPEs which connect to that Base Station should be configured to Multi-Client mode.
Base Station ID: Edit VBS/VLAN Settings.
Modulation: For this model, the modulation is OFDM.
Channel / Frequency: Select the appropriate channel/Frequency from the list provided to
correspond with your network settings.
Data Rate: The basic transfer rates should be set depending on the speed of your wireless
network. To specify rate of data transmission, select the desired rate from the drop-down
menu and choose “Best” to adapt the rate to the best available.
correspond with your network settings.
Data Rate: The basic transfer rates should be set depending on the speed of your wireless
network. To specify rate of data transmission, select the desired rate from the drop-down
menu and choose “Best” to adapt the rate to the best available.
Output Power:
Set the transmit signal strength of RADIO. The options are full, half, quarter, eighth
and min. Decrease the transmit power if necessary. The best performance for max. throughput test is
preset at the “full” setting.
preset at the “full” setting.
It
should be selected again after being reset.