ICOM ic-r2 User Manual
16
6
SCAN OPERATION
■
Full/band/programmed scan
q
Select VFO mode with [V/M].
w
Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 10)
e
Select the desired scan range, if desired.
➥
Select scan edges in scan edge set mode:
“ALL” for full scan, “BAND” for band scan or “PROG 0”–
“PROG24” for programmed scan. (see the next page)
“PROG24” for programmed scan. (see the next page)
r
Push [FUNC] + [
] or [
Z
] momentarily to start the scan.
• Decimal point flashes while scanning.
• “P SKIP” flashes when the frequency skip function is turned ON.
• “P SKIP” flashes when the frequency skip function is turned ON.
(p. 19)
• “0P”–“24P” flash to indicate which pair of scan edges is being
scanned.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
t
To stop the scan, push [FUNC] + [
] or [
Z
] again.
If the same frequencies are programmed into a pair of
scan edges, programmed scan does not start.
scan edges, programmed scan does not start.
For programmed scan, scan edges must be programmed
in advance. Program scan edges in the same manner of
programming a memory channel and select a scan edge.
(p. 17)
in advance. Program scan edges in the same manner of
programming a memory channel and select a scan edge.
(p. 17)
■
Memory (bank) scan
q
Select memory mode with [V/M].
w
Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 10)
e
Turn the memory bank scan ON or OFF in the memory
scan set mode, if desired.
scan set mode, if desired.
• See below for details.
r
Push [FUNC] + [
] or [
Z
] momentarily to start the memory
(bank) scan.
• Decimal point flashes while scanning.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
t
To stop the scan, push [FUNC] + [
] or [
Z
] again.
D
Memory bank selection
q
Select memory mode with [V/M].
w
While pushing [FUNC], push [BAND] to enter memory
scan set mode.
scan set mode.
e
Rotate [DIAL] to select the memory bank scan ON or OFF.
• “ALL” indicates all memory banks are
scanned (memory bank scan OFF);
“BANK” indicates memory bank scan
is turned ON.
“BANK” indicates memory bank scan
is turned ON.
r
Push [BAND] to exit memory scan
set mode.
set mode.
Bank scan ON