Philips Pocket projector PPX1430 PPX1430/EU User Manual

1 Insert the small plug of the power supply into the

socket on the rear side of your device. 

2 Plug the power supply into the mains.

3 During the charging process, the indicator light on

the top of the device will be red. When the battery
is fully charged, it will turn green.

4 Charge the built-in battery before using for the first

time for at least 3 hours. This will prolong, the life of
the battery.

1 Switch the device on using the on/off switch on the

side.

2 Turn the device towards an appropriate projection

surface or wall at a distance of at least 0,2m and at
most 3m. Make sure the projector is in a secure
position.

3 Use the focus wheel on the top to adjust the image

sharpness.

4 Select the desired menu language using ¡/¢.

5 Confirm with à.

Risk of explosion with incorrect type of batteries

1 To access the battery, disengage the locking mecha-

nism (‚) and slide out the battery compartment
(ƒ).

2 Insert the new batteries into the battery compart-

ment with the positive and negative poles as shown
on the back of the remote control. Make sure the
polarities(+ and -) are aligned correctly.

Check whether the mains voltage of the
power supply matches the mains voltage avail-
able at the setup location.

The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Select with the navigation keys Settings.
2 Confirm with à.
3 Select using ¡/¢ Language.
4 Confirm using à.
5 Select the desired language with ¡/¢.
6 Confirm with à.
7 You can exit with ¿.

Use only batterytype:CR 2025.

CAUTION! RISK OF EXPLOSION IF BAT-
TERY IS REPLACED BY ONE OF AN
INCORRECT TYPE.