Altronix HUBWAYLD16DI Leaflet

Altronix HubWayLD16Di Active UTP
Transceiver Hub w/Integral Isolated Camera
Power transmits UTP video, RS422/RS485
data and power over a single CAT-5 or
higher structured cable. Unit provides 16
camera channels in a space saving 1U EIA 19” rack mount
chassis which may be rack, wall or shelf mounted. Video transmission range is up to 3000 ft. max. per channel.
Units are compatible with AC and/or DC fixed or PTZ cameras when utilizing Altronix HubWayAv, HubWayDv or
HubWayDvi Video Balun/Combiners. In addition, the unit features individually selectable 24VAC or 28VAC fuse
protected outputs with surge suppression. An optional HubSat4D Passive UTP Transceiver Hub with Integral
Isolated Camera Power can be used as an accessory module to transmit video from up to 4 cameras over a single
CAT-5 or higher structured cable back to the HubWayLD16Di. In addition, the HubSat4D provides power to these
cameras locally to eliminate the possibility of voltage drop associated with long cable runs.

• 115VAC 60Hz, 5 amp

or 230VAC 50/60Hz, 2.5 amp.

• Primary fuse (internal) is rated at 5 amp/250V.

• Sixteen (16) channels of video over twisted pair

up to a distance of 3000 ft. per channel.

• Sixteen (16) 75 ohm video outputs.

• RS422/RS485 data inputs.

• Individually selectable 24VAC or 28VAC power 

outputs with OFF position.

• Electronically isolated camera power.
• Class 2 Rated power limited outputs.
• PTC protected outputs are rated @ 1 amp

per channel.

• Unit provides up to 1 amp max. per channel not to 

exceed a total of 16 amp maximum current.

• Surge suppression.

• AC input power indicator.
• Video signal and power LED indicators.

• Picture and Gain control.
• Illuminated master power disconnect circuit breaker

with manual reset.

• IEC 320 - 3-wire grounded line cord (detachable).
• Unit can be rack, wall or shelf mounted.
• 1U EIA 19” rack mount chassis.

• Optional HubSat4D allows transmission of up to 

four (4) video signals over a single CAT-5 or higher
structured cable.

• Video Balun/Combiners:

- HubWayAv - for use with 24VAC cameras.
- HubWayDv - for use with 12VDC cameras.
- HubWayDvi - for use with 12VDC 

cameras without isolation.

- HubWayLD16Di: 22.15 lbs.
- HubWayLD162Di: 23.55 lbs.
- HubWayLD163Di: 24.55 lbs.

Active UTP Transceiver Hub with Integral Isolated
Camera Power. Video Balun/Combiners not included.
HubWayLD162Di

Active UTP Transceiver Hub with Integral Isolated
Camera Power with sixteen (16) HubWayAv Video
Balun/Combiners.

Active UTP Transceiver Hub with Integral Isolated
Camera Power with sixteen (16) HubWayDv Video
Balun/Combiners.

Rev. DSHubWayLD16Di - E20I

UL Listed for Commercial CCTV Equipment
(UL 2044).

CUL Listed - CSA Standard C22.2 No.1-04,
Audio, Video and Similar Equipment.