TP-LINK TL-WDN4200 User Manual

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures: 

• 

Reorient or relocate the receiving antenna. 

• 

Increase the separation between the equipment and receiver. 

•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.   

• 

Consult the dealer or an experienced radio/ TV technician for help. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: 

1）  This device may not cause harmful interference. 
2）  This device must accept any interference received, including interference that may 

cause undesired operation. 

Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment. 
 
Note: The manufacturer is not responsible for any radio or TV interference caused by 
unauthorized modifications to this equipment. Such modifications could void the user’s authority 
to operate the equipment. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. End users must follow the specific operating instructions for satisfying RF 

exposure compliance. This transmitter must not be co-located or operating in conjunction with 

any other antenna or transmitter. This equipment has been SAR-evaluated for use in hand. 

SAR measurements are based on a 5mm spacing from the body and that compliance is 

achieved at that distance. 

 

This is a class B product. In a domestic environment, this product may cause radio interference,