TP-LINK TD-W8920G User Manual

Off 

The Wireless function is disabled 

Slow flash 

The Wireless function is enabled 

WLAN 

Quick flash  Sending or receiving data over wireless network 

Off 

There is no device linked to the corresponding port 

On 

Connected to a device through the corresponding port 

(1-4) LAN 

Flashing 

Sending or receiving data over corresponding port 

The Router's ports, where the cables are connected, and RESET button are located on the back 

panel. 

 

Figure 3-2 

¾  Line: Connect to the Modem Port of Splitter or to the telephone line. 
¾  Reset Button: There are two ways to reset the Router's factory defaults. Press the reset 

button of the Router, and then power on the Router, hold reset button pressed down for about 

five seconds, or restore the default setting from “Management - Settings - Restore Default “of 

the Router's Web-based Utility. 

¾  1, 2, 3, 4 (LAN): Through these ports, you can connect the Router to your PCs and the other 

Ethernet network devices. 

¾  Power: The Power plug is where you will connect the power adapter. 
¾  Antenna: Used for wireless operation and data transmit. 

¾  Make sure your computer has a Networking Interface Card (either wired or wireless is ok) 

 11