TP-LINK TD-W8950ND User Manual

Type the new value for the WAN Interface who’s MAC Address you want to change. 

You can select corresponding WAN Interface from the drop-down list and click Clone button to 
clone your current PC MAC. 

Click Restore Default button to restore the WAN Interface’s default MAC Address. 

)

Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not 
be the same with each other. 

Choose “Advanced Setup”Æ“LAN”, and you will see the LAN screen (shown in Figure 4-21), the 
section allows you to configure the modem router’s LAN ports settings. 

 

Figure 4-21 

¾

  IP Address: You can configure the modem router’s IP Address and Subnet Mask for LAN 

Interface. 

•  IP Address: Enter the modem router’s local IP Address, then you can access to the 

Web-based Utility via the IP Address, the default value is 192.168.1.1. 

•  Subnet Mask: Enter the modem router’s Subnet Mask, the default value is 255.255.255.0. 

¾

  Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard 

Mode or Blocking Mode. 

¾

  DHCP Server: These settings allow you to configure the modem router‘s Dynamic Host 

Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for the 
modem router’s Ethernet LAN interface. DHCP service will supply IP settings to computers 
which are configured to automatically obtain IP settings that are connected to the modem 
router though the Ethernet port. When the modem router is set for DHCP, it becomes the 

31