TP-LINK TL-ER6020 User Manual

02

 Gigabit Dual-WAN VPN Router

Interface

Description

WAN

The WAN port is designed to connect the Router to the interface provided 

by ISP via the RJ45 cable

LAN

The LAN port is designed to connect the Router to the local PCs or 

switches by the RJ45 cable

DMZ

The DMZ port is designed to connect the Router to the servers

Console

The Console port is designed to connect with the serial port of a computer 

or terminal to check and monitor some simple system information of the 

Router

Use  the  button  to  restore  the  Router  to  the  factory  defaults.  With  the  Router 
powered on, use a pin to press and hold the Reset button (about 4~5 seconds1. 
After the SYS LED goes out, release the Reset button. If the SYS LED is flashing 
with a high frequency about two or three seconds, it means the Router is restored 
successfully.

■

The rear panel of TL-ER6020 is shown as the following figure.

Rear Panel

Figure 1-2 

Connect the female connector of the power cord here, and the male connector to 
the AC power outlet. Please make sure the voltage of the power supply meets the 
requirement of the input voltage.

The Router already comes with lightning protection mechanism. You can also ground 
the Router through the PE (Protecting Earth1 cable of AC cord or with Ground Cable. 
For detailed information, please refer to Chapter 3 Lightning Protection.

The Router provides one security slot.

Caution: Please use the provided power cord.

Introduction