TP-LINK TL-WR340GD User Manual

 

 

36

the PC that triggered this rule. You can input at most 5 groups of ports (or port section). 

Every group of ports must be set apart with ",". For example, 2000-2038, 2050-2051, 2085, 

3010-3030. 

¾ 

Incoming Protocol - The protocol used for Incoming Ports Range, either TCP or UDP, or 

ALL (all protocols supported by the router). 

¾ 

Status - The status of this entry either Enabled or Disabled. 

To add a new rule, enter the following data on the Port Triggering screen.   

1. Click 

the Add New button. (pop-up Figure 3-31) 

2.  Enter a port number used by the application when it generates an outgoing request.     

3.  Select the protocol used for Trigger Port from the pull-down list, either TCP, UDP, or All. 

4.  Enter the range of port numbers used by the remote system when it responds to the PC's 

request. 

5.  Select the protocol used for Incoming Ports Range from the pull-down list, either TCP or 

UDP, or All. 

6. Select 

the 

Enable checkbox to enable.   

7. Click 

the 

Save button to save the new rule. 

 

Figure 3-31 Add or Modify a Triggering Entry 

There are many popular applications in the Popular Application list. You can select it, and the 

application will fill in the Trigger Port,  incoming Ports Range boxes and select the Enable 

checkbox. It has the same effect as adding a new rule. 

To modify or delete an existing entry: 

1. Click 

the 

Modify  in the entry you want to modify. If you want to delete the entry, click the 

Delete. 

2.  Modify the information.   

3. Click 

the 

Save button. 

Click the Enable All button to make all entries enabled 

Click the Disabled All button to make all entries disabled. 

Click the Delete All button to delete all entries