TP-LINK TL-SC3230N User Manual
26
of a network scan. Access points with a disabled SSID Broadcast will not appear unless the
camera is associated with it. The following information is provided:
camera is associated with it. The following information is provided:
¾
Interface Select: “Wired (Ethernet) only” or “Auto – wired if cable is connected, otherwise
wireless”: Choose wired or wireless mode. However, note that wired is priority.
¾
Type: To select one of WLAN modes from Infrastructure or Ad-Hoc mode.
¾
SSID: This is the name of the wireless network the camera is configured for. The field
accepts up to 32 alphanumeric characters. The name must be exactly the same as that used
in the wireless access point, or the connection will not be established. Leaving this field blank
means the camera will attempt to access the nearest open network.
in the wireless access point, or the connection will not be established. Leaving this field blank
means the camera will attempt to access the nearest open network.
¾
Channel: Chooses the wireless channel in use currently.
¾
Security mode: Shows which type of security the network uses. The camera supports three
security methods: None, WEP, WPA_PSK/WPA2_PSK.
WEP settings:
- Authentication: Select “Open or Shared Key System Authentication”, depending on the
method used by your access point. Not all access points have this option, in which case they
probably use “Open System”, which is sometimes known as SSID Authentication.
method used by your access point. Not all access points have this option, in which case they
probably use “Open System”, which is sometimes known as SSID Authentication.
- WEP Mode: The access point being used determines which key type is available. The
following options are available:
following options are available:
•ASCII - In this method the string must be exactly 5 characters for 64-bit WEP and 13
characters for 128-bit WEP.
characters for 128-bit WEP.
•HEX - In this method the string must be exactly 10 hexadecimal (0-9, A-F) characters
for 64-bit WEP and 26 hexadecimal characters for 128-bit WEP.
for 64-bit WEP and 26 hexadecimal characters for 128-bit WEP.
- Web Key 1~4: Key value of WEP.
WPA settings:
- WPA Key: Key value of WPA. The camera uses a pre-shared key (PSK) for key
management. The pre-shared key can be entered either as Manual hex, as 64 hexadecimal
characters, or as a Passphrase, using 8 to 63 ASCII characters.
management. The pre-shared key can be entered either as Manual hex, as 64 hexadecimal
characters, or as a Passphrase, using 8 to 63 ASCII characters.
¾
Obtain IP address automatically (DHCP): Enable this checkbox when a DHCP server is
installed on the network to issue IP address assignment. With this setting, the IP address is
assigned automatically.
assigned automatically.
¾
IP address, Subnet mask, and Gateway: If you do not select Obtain an IP address
automatically, then you need to enter these network parameters manually.
Select OK to save and enable the setting.
)
Note:
To enable WLAN function, the user must set these related parameters correctly at first. Then
power off the camera and remove Ethernet cable from camera. Power on the camera again and
WLAN mode will be available accordingly.
power off the camera and remove Ethernet cable from camera. Power on the camera again and
WLAN mode will be available accordingly.