Trendnet TEW-210APB User Manual

1.  Mount the Access Point firmly to the wall or proper location that is 

determined during the site survey.   

2.  Make sure the antennas are in a vertical position (if not, rotate over 90 

degrees). 

 

3.  Insert the power connector. 

 

4.  Attach the UTP Ethernet cable to the Access Point. 

 

 

 

At the front of the Access Point you will see three LEDs.   

If all goes well, the middle LED (power) and the lowermost LED(LINK) will fire 

and uppermost LED(ACT) will flash whenever there is traffic on the respective 

networks which is at least ten times per second for the wireless LAN because 

of so-called ‘beacons’.   

 

You can reset the Access Point’s settings to factory defaults by pushing a 

paperclip in the little hole next to the power connector.   

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4