Trendnet TVP-224HR User Manual

TVP-224HR User’s Guide 

115

 

 

The console port uses a DB-9 RS-232 connector. The supplied straight through RS-
232 cable connects the console port of the TVP-224HR to a console PC or terminal.  
 

Connect RS-323 Cable to TVP-224HR RS-232 
console port a your computer that you will use as 
a configuring terminal 

 

 

Open HyperTerminal and enter the following Input 
Parameters when prompted: 

Baud rate              
Number of data 
bit 
Parity check 
Number of stop 
bit 
Flow control 

19,200 

8 

None 

1 

None 

When the empty HyperTerminal Screen appears 
type “123” 

 

 

123 

In the event that you forget your administration 
password,  you can gain console access to the 
TVP-224HR using the super password. The super 
password is the last six digits of your MAC 
address located on the bottom of your TVP-224HR 
(00-50-2d-xx-xx-xx). At the Console prompt enter 
the super password without hyphens. The 
password is all lower case. After gaining access, 
at the console prompt type in 
 

 
If entry of new password is successful, the console 
will list “OK”. You will now be able to gain Web 
Access from a PC in the same local segment 
using the TVP-224HR LAN IP Address. If  Web 
and / or Telnet Access are enabled, you will also 
be able to remote access the TVP-224HR by 
entering http:// followed by the TVP-224HR WAN 
IP or domain name. 

 

 

At the prompt 
Console> 
Enter ping 168.95.1.1 
The following dialogue indicates that Internet 
Access is successful. 
 

Console>

 

ping 
168.95.1.1