Smeg PTS723-3 User Manual

 

 

 

Refers to the gap “X” in mm. 

30/37 mbar 

8 mbar 

20 mbar 

Semi rapid (1) 

10.0 

1.5 

2.0 

Rapid (2) 

8.0 

1.5 

2.5 

 

Ultra-Rapid (3) 

12.0 

5.0 

2.5 

To identify the burners on your hob, refer to the drawings in point “5.8 Hob burner 
layout” 
 

Reverse the procedure described in point “5.1 Removing the hob skin ”. 
 

 

 

 

 

Put the pan stands back in place, fitting first those at the side and then the central one.

Reassemble the components on the burner and fit the 
knobs onto the tap rods. 

Light the burner and turn it to the minimum   setting . 
Remove the knob again and adjust the regulator 
screw inside or beside the tap rod (depending on the 
model) until an even minimum flame is obtained. 
Put the knob back in place and check the stability of 
the burner flame (the flame must not go out when the 
knob is turned quickly from the maximum to the 
minimum setting).  

 

To adjust the minimum level when using bottled gas, the adjuster screw inside or 
beside the tap rod must be turned fully clockwise (depending on the models). 
The diameters of the bypasses for each individual burner are stated in point “5.2 
Adjusting for bottled gas".